Gay Cruising Windsor On

Puff Top - Part 1 and Marie's bands madness

I am there and poof ...;. I must say after I have everything tailored for the top, I was pretty discouraged because I was forever long and in that sense nothing went on except that there were more parts. I learned then in between the high school and then kicked me again pre iron, ironed everything, and then sewn schonmal but sometimes the pink band = D. My goal for tomorrow is the sleeves, the pink band in the Back and the mesh of the front part.

As it is now very slowly with documentation = D.
First you need once the fabric strips. It begins to be superior to - how wide should it be? For the front I have decided to 5cm, for the arm at 3rd Of course you have to cut a little wider, so that it can also umbügeln. To help (very good imo), I've cut out cardboard templates bracket with 5 and 3. Now it goes to the temples. Stencil in the middle and then you start either the top or bottom (only one page!) And iron .. and fits on your finger. You must of course keep the fabric and pull it up, but do not directly before the iron tip, which is painful. Requires so much patience (yes * g *), a good feeling ~ dealing with the iron. It burns you up fast fingers, looking as you can!



After that insert pins into her so that now ironed edge also keeps well.


It looks as of right this:


then the other side as well:


Et voila


That makes it the template as 5cm.

Then I even ironed the parts so far as is now was just:


To illustrate, I times the band upped the ante.


drauflegen Then on a smooth surface (!) Top and stuck nicely with pins (ie the band). Let's cut away rather turn to the longer lengths, you can still afterwards. Oh, I have the pink on it so put the first offset to the rear, because weggenäht be 1.5 cm as a form fill - that is done then it starts the same with the pink ribbon. No idea? No problem, I'll show you when I'm ready.



And the sleeve 2s.


After that I still sewn on the tape. Tomorrow I will then =). Although I have a bit of the pink part made in the back but forgot to take pictures .. I get to tomorrow!